for this card I stamped the truck from the fast and furious stamp set in honey ink and fussy cut it out. I cut the tires from the scalloped circle on art philosophy but next time will just stamp them in black and cut them out because I had to stamp them for the hub caps anyway. I marked 3/4 inch from the bottom of the card and 1 inch on both sides and half inch from the bottom mark, then used my paper trimmer to cut out the run. The pull tab is a 6 3/4 long 3/4 inch wide piece of scrap stamped in cranberry ink. I used 3d foam tape along the top and bottom of the track and glued a piece of 4 1/4 x 5 1/2in card stock on the inside panel. I then put the pull tab between the two fronts into the “pocket” that was created using the foam tape and pop dotted the truck to the tab.